COLEMAN LANTERN LIGHT HOW TO
COLEMAN LANTERN LIGHT INSTALL

If you need help installing the Mantle(s) please click here.Ĩ. This will clear dirt and insect nests out of the tubes. Use an air compressor to blow-out the burner assembly by holding the air nozzle under the burner cap(s) and blowing air up into the lantern. Place your finger over the hole in the air intake tube where the generator just came out of. If you need help removing the generator please click here.ħ. If the pump raises, you need to clean or replace your check valve. Press the pump handle down and lightly place your finger over the hole in the end. If there is no resistance when pressing down on the pump, you will need to repair it before continuing.Ħ. Rotate the pump handle counterclockwise one full turn, place your thumb over the hole in the end and give it a few pumps. Make sure that the valve wheel is turned fully clockwise to the closed position. If the fount is excessively rusty please refer to our rebuild pages for help.ĥ. Repeat until the liquid coming out is clear.

COLEMAN LANTERN LIGHT INSTALL

Install the cap and shake the fount vigorously for a few minutes, then pour it out.

Wash out the fount with a small amount of clean fuel or denatured alcohol. A new replacement cap is critical for safety and will keep your lantern pressurized longer.Ĥ. Unless you know it is less than a few years old, always replace the fuel filler cap. If it smells real bad you might need to tear it apart to clean the internal parts. Varnish can coat the internals and block them. If it has a strong really sharp smell, that is varnish from old gasoline that has gone stale. You can find a local hazardous waste recycling facility by doing an internet search.ģ.

Remove the fuel filler cap and pour all the old fuel into an approved container for disposal. Remove as much dirt and dust as you can and remove the old mantle(s).Ģ. Remove the ventilator and globe, then spray the lantern with a household cleaner like Simple Green®. Please click here to see an exploded view of a lantern that will open in a new browser.ġ. If you need to make any repairs, I will provide links to other sections of this website. This will help you confirm that your lantern is safe to use, and that it functions as in should. If you have no previous knowledge of the lantern you are working with, or if you do not know how long it has been sitting, please perform each step. These instructions were written to help you safely light and operate an old lantern that you have not lit before, or has been in storage for a very long time.Īn old or dirty lantern can quickly turn into a raging inferno if you don’t know what you are doing and/or are not careful.įirst, please take the time to read our Lantern Safety page.

COLEMAN LANTERN LIGHT HOW TO

Old Town > Learn > How-to > Light an old lantern How to Light an old Coleman® Lantern

Coleman lantern light